Radio Operation; Band Button; Tune/Seek Up/Down Buttons; Aps Button - Lenco CS-460 Manual De Instrucciones

3.

Radio Operation

1. BAND BUTTON

Press the BAND button on the front panel to select your desired
radio band of FM1, FM2, FM3, AM1 and AM2, and the selected
band will be displayed on the monitor of the front panel, press
1-6 buttons to select your favour.
Press and hold this button again to select RDS function such as :
PTY, AF, TA, ST, LOC, LOUD by rotate VOL knob.

2. TUNE/SEEK UP/DOWN BUTTONS

1) Press and hold the UP/ DN button to automatically search up/
down for a available station from the current frequency.
2) Briefly press the UP / DN button to manually search up or down with step by step for
your desired station from the current frequency.

3. APS BUTTON

1) When press and hold the APS button, the radio searches from the lowest frequency and
checks the signal strength level until 1 cycle search is finished. And then the 6 strongest
stations are preset to the corresponding preset number memory bank. The AS operation
is implemented in each bank of the selected band. When the AS operation is finished,
the radio executes the preset scan, and after preset scanning for one cycle, it will stop
scanning and broadcasting the No.1 station for Fm1.
(It can store 3x6 stations for FM and 2x6 stations for AM in all)
2) When press the APS button briefly on the front panel or the remote control, the radio
searches for each preset station from the M1. When the field strength level is more than the
threshold level of the stop level, the radio holds at that preset number for few seconds with
releasing mute, and then searches again. After finishing a circle of searching, it will stop
searching on the M1.
NOTE: In FM band, FM1,FM2,FM3 is checked one at a time.
In AM band, Am1, Am2 is checked one at a time.
4. PRESET STATION [ 1-6 ] BUTTONS
1) To memorize the current frequency on the current band, press and hold any one of the six
Number buttons (1-6) .
2) To recall the memory station on the current band, press one of the Number buttons [1-6] .

5. STEREO/MONO BUTTON

Press the ST button on the remote control to select the STEREO or MONO sound mode for
FM band.

6. LOC BUTTON

1) When the signal of the distance radio station are very weak and the receiving effect is bad
during tuning, check whether there is the word LOC on LCD. If there is the word LOC
on LCD, press this button to turn off the LOC function, then tune again for the distance radio
station;
2) When the signals from the local radio stations are too strong, this could lead to interference.
10
Radio interface-1
Radio interface-2