Tabla de contenido
Idiomas disponibles
Idiomas disponibles
THE STARPOINTER FINDERSCOPE
The StarPointer is the quickest and easiest way to point your telescope exactly at a desired object in the sky It's
like having a laser pointer that you can shine directly onto the night sky The StarPointer is a zero magnification
pointing tool that uses a coated glass window to superimpose the image of a small red dot onto the night sky
While keeping both eyes open when looking through the StarPointer, simply move your telescope until the red dot,
seen through the StarPointer, merges with the object as seen with your unaided eye The red dot is produced by a
light-emitting diode (LED); it is not a laser beam and will not damage the glass window or your eye The StarPointer
comes equipped with a variable brightness control and two axes alignment control Before the StarPointer is ready
for use, it must be attached to the telescope tube and properly aligned
STARPOINTER INSTALLATION
1 Loosen the two mounting screws near the bottom of the
finderscope
2 Slide the base of the finderscope over the finderscope
mounting bracket found on the telescope optical tube
3 Tighten the screws to secure the finderscope in place
Your StarPointer finderscope is shipped with a clear plastic
tab inserted between the battery and the contact to prevent
the battery from accidentally being discharged in shipment
Pull this tab out before using your finderscope
ATTACHING THE HAND CONTROL
The NexStar SLT hand control has a phone jack type
connector at the end of its cord Plug the phone jack
connector into the outlet at the base of the telescope's fork
arm Push the connector into the outlet until it clicks into
place and place the hand control into its holder as described
previously in the Assembly section of the manual
10 I
ENGLISH
Power/Brightness Knob
Up/Down
Adjustment Knob
Mounting Screws
On/Off Switch
Left/Right
Adjustment Knob
Auxiliary Port
Hand Control Port
Hand Control Port
12 V Power Outlet
Capítulos
Tabla de contenido
