Classe CP-65 El Manual Del Propietario página 9

RS-232 SERIAL COMMANDS
The CP-65 Remote Control Preamplifier can be controlled using the RS-232 DB-9 port on the back of
the main unit. To properly communicate with the CP-65 you must configure the controlling device to
communicate at 9600 baud, 8 bits, no parity,1 stop bit with hardware control enabled.
To query the units current state enter the "?" and the following output will be returned.
P=1 Power status – 1 show the the unit is ON, 0 if OFF
I=L1 Input status – L1, L2, L3 for Line, B1,B2,B3 for Balanced
S= 00.0
Level status – UN1 or UN2 if input set to Unity Gain with mute on or off. : 00.0 for offset
value
T=0 Tape monitor status – 1 for Tape 1, 2 for Tape 2, 0 if tape monitor is OFF
O=3 Output Status 1 – for output 1, 2 for output 2, 3 for both outputs enabled
V= 00.0 Volume Status – Current displayed volume 00.0
M=0 Mute Status – 0 if mute is OFF, 1 if mute is ON
B=00.0 Balance Status – 00.0 if in balance. 01.5R indicates that the right channel is -1.5db
RS-232 Command Set
PWR Toggles power
PW1 Turns power ON
PW0 Turns power OFF
MUT Toggles mute
MU0 Turns mute OFF
MU1 Turns mute ON
DDD Toggles display brightness
DDB= Sets display turn off time (2 Digit entry to 99 seconds). Entey of less than 05 turns OFF
blanking
VU1 Volume up control. (0.5db per entry)
VD1 Volume down control (-0.5db per entry)
VU5 Volume up control (5.0db per entry)
VD5 Volume down control (-5.0db per entry)
DBL Shifts balance left 0.5db
DBR Shifts balance right 0.5db
DL1 Selects LINE 1
DL2 Selects LINE 2
DL3 Selects LINE 3
DB1 Selects BAL 1
DB2 Selects BAL 2
DB3 Selects BAL 3
DT1 Selects TAPE1
DT2 Selects TAPE2
DT0 Selects SOURCE (Exits Tape loop)
DO1 Turns on OUTPUT1
DO2 Turns on OUTPUT2
DO3 Turns on both outputs
LPI List programmable items and the current value. See below
OB1=00.0
NB1=*****
OB2=00.0
NB2=*****
OB3=00.0
NB3=*****
OL1=00.0
NL1=*****
OL2=00.0
NL2=*****
OL3=00.0
NL3=*****
OT1=00.0
OT2=00.0
DDB= OFF
Level of BAL1 input
Name of BAL1 input
Level of BAL2 input
Name of BAL2 input
Level of BAL3 input
Name of BAL3 input
Level of LINE1 input
Name of LINE1 input
Level of LINE2 input
Name of LINE2 input
Level of LINE3 input
Name of LINE3 input
Level of TAPE1 input
Level of TAPE2 input
Display set to OFF
5