4
E-100-LR Light Retrofit Installation Instructions
5a
• Notch core.
• Peel bus wire from core.
• Score core between
bus wires at jacket.
Do not cut
bus wires.
• Bend and snap core.
• Peel core from bus wires.
• Remove any remaining core
material from bus wires.
CAUTION: Health Hazard.
Wash hands if you contact seal-
ant. Consult MSDS VEN0033.
• If needed, retwist
Make sure the
and straighten
bus wires do not
kink, bunch, or
bus wires.
crossover.
• Insert bus wires
into guide tubes
as shown.
• Slide core sealer onto
heating cable.
• Remove the guide tubes and
dispose of them in a plastic
bag.
BTV, QTVR
Go to Step 6
5b
Do not cut
• Cut and remove
bus wires.
all fiber strands.
• Score and remove center
spacer.
• Remove any remaining core
material from bus wires.
CAUTION: Health Hazard.
Wash hands if you contact seal-
ant. Consult MSDS VEN0033.
• If needed, retwist
Make sure the
and straighten
bus wires do not
kink, bunch, or
bus wires.
crossover.
• Insert bus wires
into guide tubes
as shown.
• Slide core sealer onto
heating cable.
• Remove the guide tubes and
dispose of them in a plastic
bag.
Strip length guide for BTV, QTVR, XTV and KTV
mm
10
20
in.
1
XTV, KTV
Go to Step 6
30
40
50
60
2
70
80
80
3