Assembly; Install Trimmer Head To The Cutting Head; Install Trimmer Head Guard - Briggs & Stratton Murray 866015 Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

WaRNING
Unintentional sparking can result in fire or electric
shock.
Unintentional start-up can result in entanglement,
traumatic amputation, or laceration.
Fire hazard.
Before performing adjustments or repairs:
• Disconnect the spark plug wire and keep it away from the
spark plug.
• Use only correct tools.
• Replacement parts must be the same and installed in the
same position as the original parts.
• STOP engine.
• Avoid serious burns. Allow all parts to cool before
working on machine.

Install Trimmer Head to the cutting Head

1. Align the hole on the cutting head (a, Figure 5) to the
notch (B) on the spline pad (c).
2. Use Allen Wrench (D) to hold spline pad in position.
3. While holding Allen wrench in place, install the
trimmer head (e) by turning in a counterclockwise
direction.
NOTe: Ensure that the spline pad is placed in the correct
position when installing. The shoulder side must
face the cutting head.
D
c
e
Figure 5

aSSeMBlY

Install Trimmer Head Guard

1. Remove the two screws (a, Figure 6) from guard.
2. Position guard and saddle (B) at hole in straight shaft.
3. Install the two screws through the saddle and into the
guard.
4. Remove third screw (c) from the tool set bag, and
install into the drive shaft.
NOTe: The third screw (c) is shorter than the two screws (a)
c
Figure 6
a
B
11
installed in guard.
a
B
Tabla de contenido
loading

Este manual también es adecuado para:

Murray 866019

Tabla de contenido