oneConcept Beaufort Manual Del Usuario página 35

Now look at the bubble level. The bubble should be fully inside the red circle. If it is not,
wind direction, speed, and rain readings may not operate correctly or accurately. Adjust the
mounting pipe as necessary. If the bubble is close, but not quite inside the circle, and you
cannot adjust the mounting pipe, you may have to experiment with small wooden or heavy
cardboard shims between the sensor package and the top of the mounting pole to achieve
the desired result (this will require loosening the bolts and some experimentation).
Make sure you check, and correct if necessary, the westly orientation as the final installation
step, and now tighten the bolts with a wrench.
Reset Button and Transmitter LED
Using a bent-open paperclip, press and hold the RESET BUTTON (see Figure 10) to affect a
reset: the LED turns on while the RESET button is depressed, and you can now let go. The
LED should then resume as normal, flashing approximately once every 48 seconds.
9
Note: Beside the antenna, there is an arrow
icon with "WEST" words (Figure 9)representing
the direction of west. The sensor body has to be
adjusted so that the "WEST" indication is facing
to real west direction in your location. A compass
device is recommended to help adjust direction.
Permanent wind direction error will be introduced
when the outdoor sensor is not installed in right
direction.
35