oneConcept Beaufort Manual Del Usuario página 31

1. Wind Speed Sensor
2. Wind Vane
3. Thermo-hygro sensor
4. Rain collector
5. Bubble level
6. Solar panel
Install U-bolts and metal plate
Installation of the U-bolts, which are in turn used to mount the sensor package on a pole,
requires installation of an included metal plate to receive the U-bolt ends. The metal plate,
visible in Figure 3 has four holes through which the ends of the two U-Bolts will fit. The plate
itself is inserted in a groove on the bottom of the unit (opposite side of solar panel). Note that
one side of the plate has a straight edge (which goes into the groove), the other side is bent at
a 90-degree angle and has a curved profile (which will end up "hugging" the mounting pole).
Once the metal plate is inserted, insert both U-bolts through the respective holes of the metal
plate as shown in Figure 3.
7. Antenna
8. U-Bolt
9. Battery compartment
10. Reset button
11. LED Indicator: light on for 4s if the unit
power up. Then the LED will flash once every
48 seconds (the sensor transmission update
period).
3
31