Technical Specifications - KlipXtreme KPM-610B Manual De Instalación

of center of gravity. Place the Projector Assembly on top of the mounting legs with the center as
close as possible to the projector's center of gravity.
Step 3
Verify that the mounting legs are all adjusted at the same level. Otherwise, if the height of mount
legs do not match or if the projector plate is not level, go to step 2 on page 9.
Verify that the supplied sliding M6 square nut in the mount leg is properly aligned with the slot on
the Projector Plate.
If the M6 square nut cannot be aligned with any nearby slot, you can use any thin implement,
such as a toothpick, to nudge it into alignment.
Tighten the M6 x 10mm hexagon screw in the projector collar assembly.
Step 1

Technical Specifications

All measurements are in millimeters.
Step 2
Side-to-side
Center of gravity
Front-to-back
Center of gravity
Step 3
Sliding M6
Square Nut