Fellowes Quasar Wire Manual De Instrucciones página 3

SET UP
1
1. Ensure the machine is on a
stable surface.
BEFORE YOU BIND
1
1. Select the correct wire comb
diameter using the comb
storage tray.
STEPS TO BIND
1
Max 15
30
(80gsm)
1. Punch sheets in small
batches that do not overload
the machine or user.
5
5. Lift the wire closing lever
forwards. The closing scale guide is
on the moving jaw. Close the jaws
until the wire gauge shows the size
of wire being closed.
2
2. Check waste tray is empty
and correctly fitted.
2
2. Hang the selected wire
comb onto wire comb support.
2
2. Starting with the rear cover.
Load punched sheets directly onto
the hanging open wire comb.
6
6. Check the closed seam. If
the seam is not closed correctly,
the document can be placed
into the jaws and closed again.
3
3. Lift the lid. Ensure the wire
closing lever is pushed backwards.
3
3. Test punch scrap sheets to
check edge guide setting.
3
3. Punch and hang the front
cover. Punch and hang the
remaining sheets.
7
7. To hide the seam, turn the
rear cover backwards. The front
cover is now visible. The seam is
hidden inside the document.
4
4. Lift the punch handle to its
upright position.
4
4. Lift the wire comb upwards off the
hooks. Carefully place into the open
wire closing mechanism. Ensure the
wire comb is open and touching the
bottom of the mechanism.
8
8. Check wire seam closure is
complete. Loose binding allows
sheet loss. Good closure retains
all sheets.
3