Denver Electronics CR-425 Manual De Instrucciones página 5

POWER SUPPLY
The unit can be powered by either AC power or batteries.
OPERATING THE UNIT ON AC POWER
Insert one end of the supplied power cord to the DC jack at the rear of the unit, and the
other end into the wall outlet.
When connecting the power cord, make sure that the power cord is firmly pushed into the
DC jack and the wall outlet for power supply.
OPERATING THE UNIT ON BATTERIES
1. To operate the unit on batteries, the AC power cord must be disconnected from the unit.
2. Unplug the AC power cord from the unit and insert 3 AA batteries (not included) in the
battery compartment.
3. Close the battery compartment door.
1.5V AA
Batteries
Note: Check your batteries regularly. Old or depleted batteries should be replaced. If the
unit is not to be used for some time, or is being run exclusively on AC power, remove the
batteries from the battery compartment to avoid battery leakage.
Warning: Before using the unit. Check that the local mains supply is compatible with the
unit. Do not plug or unplug the power cord when your hands are wet.
If you do not use the unit for a long period of time (i.e. Vacation etc.), disconnect the plug
from the wall outlet.
BATTERY SAFETY PRECAUTIONS:
• Keep the batteries away from children and pets.
• Insert the batteries observing the proper polarity (+/-). Failure to properly align the battery
polarity can cause personal injury and/or property damage.
• Remove old or depleted batteries from the product. Remove the batteries when the
product is not used for extended periods of time to prevent damage due to rust or
corrosion of batteries.
• Never throw batteries into a fire. Do not expose batteries to fire or other heat sources
• Battery Disposal: Old or depleted batteries must be properly disposed of and recycled in
compliance with all applicable laws. For detailed information, contact your local solid
waste authority.
• Follow the battery manufacturer's safety, usage, and disposal instructions.
ENG-5