Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Exceeding 42 V
By series connecting all outputs the 42 V
limit can be exceeded which means that
touching live parts may incur danger of
life! It is assumed that only qualified and
extensively instructed personnel are
allowed to operate this instrument and/
or the loads connected to it.
Correct operation
HAMEG modules are destined to be operated
normally in the mainframe HM8001-2. If they are
used in other systems it must be ensured that
they are operated with the correct supply voltages
(see specification). All applicable safety rules are
to be observed.
The instruments are destined for operation in
clean and dry rooms. Operation is precluded in
dusty or moist atmosphere , if there is danger of
explosion, and if aggressive chemicals are
present.
The operating temperature range is 0 ... + 40 de-
grees C, the strorage and transport temperature
range –20 ... +70 degrees C. In case of suspected
condensation a 2 h acclimatizing period has
to be awaited before the instrument may be
operated.
Safety regulations require that the mainframe be
only operated from mains outlets with a safety
ground connector or via an isolation transformer
of safety class 2. No special orientation of the
instrument is prescribed, however, sufficient air
circulation must be ensured. Continuous opera-
tion will require a horizontal or slightly tilted
(front feet extended) position.
The ventilation holes must not be
obstructed!
Please note: Because of electromag-
netic reasons, it is not permitted to use
STOP
two moduls of type HM8040-3 in the
same mainframe.
Warranty and Repair
HAMEG instruments are subject to a strict quality
control. All instruments are burned in for 10 hrs
prior to shipment. By intermittent operation
almost all early failures are detected. After burn-
I m p o r t a n t
in a thorough test of all functions and of quality
is run, all specifications and operating modes are
checked.
In case of reclamations during the two years
warranty period please contact the dealer from
whom you purchased your HAMEG instrument.
Customers from the Federal Republic of Ger-
many may directly contact HAMEG for warranty
processing in order to speed up the procedure.
The proceeding of repairs during the warranty
period is subject to our terms of warranty which
are available on our web-site
http://www.hameg.com
Even after expiry of the warranty period please
do not hesitate to contact our HAMEG customer
service for repairs and spare parts.
Return Material Authorization (RMA):
Before sending back your instrument to
HAMEG do apply for a RMA number either by
fax or on the Internet: http://www.hameg.de.
If you do not have suitable packaging for the
instrument on hand please contact the
HAMAG sales department (Tel.: +49 (0) 6182/
800-300, E-mail: [email protected]) to
order an empty original cardboard box.
Maintenance
This instrument needs no special maintenance
if porperly used. A moist cloth will clean it. Use a
soft detergent (water plus 1 % detergent) for the
removal of persistent dirt. Remove grease with
benzine (petrol ether). Displays and display
windows may only be cleaned with a moist cloth.
Use no alcohol, solvents or abrasives!
Under no circumstances any fluid must
enter the instrument. Other than the
STOP
STOP
specified cleaning materials may affect
plastic or lacquered surfaces.
Overtemperature protection
If an internal temperature of 75 ... 80 degrees C
is exceeded the outputs and the displays will be
turned off. This will be indicated by 3 blinking
dashes in the left and right displays. As soon as
the displays return to the normal display of the
values set the instrument will again be ready to
operate. The outputs will remain disabled until
the pushbutton OUTPUT
Subject to change without notice
h i n t s
is depressed.
21
Capítulos
Tabla de contenido
