Toshiba Regza C300 Serie Manual Del Usario página 32

Q
Q
Why are there horizontal stripes and/or blurred
images on the screen when in PC mode?
A
The Clock phase may need adjustment. Select
PC Setting from the SET UP menu, highlight
Clock phase and adjust until the picture clears.
Q
Why are there problems with text?
A
Good performance of text depends on a good
strong broadcast signal. This normally requires a
roof or loft aerial. If the text is unreadable or garbled,
check the aerial. Go to the main index page of the text
service and look for the User Guide. This will explain the
basic operation of text in some detail. If further information
is needed on how to use text see the text section.
Q
Why are there no text sub-pages?
A
There are none broadcast or they have not yet
loaded. Press the
X
(See text section).
Q
Why are the four coloured text numbers visible
but no text?
A
Text has been selected whilst viewing an external
source i.e. DVD or VCR. No text will appear on screen or a box may appear stating no information is
available. Select a broadcasting channel and press
TEXT
to access.
Q
Why doesn't REGZA-LINK work?
A
If settings on connected REGZA-LINK equipment
are changed the equipment may fail to work
correctly with television. Removing the HDMI cable then
replacing it may help. If not turn off the television, remove
the power cable from the wall socket, then plug the
television back in and switch on.
Q
Why is there no sound or picture when in
HDMI mode?
A
Some early HDMI equipment may not work
properly with the latest HDMI television products,
due to new standard adoption. Try setting Lip Sync
Latency to Off.
uestions
button to access.
A
nswers
and
Q
Why are the colours wrong when an NTSC
source is played?
A
Connect the source via a SCART lead and play.
Select Manual setting from the SET UP menu.
Set the Colour to Auto. and exit.
1
Go to the Picture settings menu and adjust
2
the tint.
Q
Why are the LEDs on the front of the television
flashing?
A
Check the table below .
LED indication
LED-2
OFF
OFF
Green
(solid)
OFF
Green
(solid)
OFF
OFF
OFF
* Digital only
** Analogue only
32
continued
Manual setting
Colour system: Auto.
EXT2 A V C R
Store
OK
Back Watch TV
MENU EXIT
Condition
LED-1
Green (solid) The TV is
operating
properly
Red (Solid) Standby with
Power-On
Red Mode set to
(solid) Active standby*
Green Sleep timer*
(solid)
Red On timer**
(solid)
RED blinks Power protect
0.5 sec cycle detection
Red blinks Abnormal
1 sec cycle operation of
BUS line
2 times Abnormal
flashing with operation
2 sec interval (initialisation
error)
Solution
Turn OFF the TV
and unplug the
power cord. Plug
the power cord
back in again and
turn ON the TV.