Craftsman 917.28936 Manual Del Operador página 26

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

4. First c onnect RED battery c able (B)to
positive ( +)battery terminal withhex
bolt a ndkeps nutasshown. Tighten
securely. Slide terminal cover ( C) over
terminal.
5. Connect BLACK g rounding cable t o
negative (-)battery t erminal withre-
maining hexbolt a ndkeps nut. T ighten
securely
6. Close h ood.
i
Negative
(Black)
Cable
TO REMOVE HOOD & GRILLASSEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. When replacing hood, be sure to re-
connect the headlight wire connector.
Headlight
Wire
Connector
Positive
(Red)
Cable
TO REPLACE HEADLIGHT
BULB
1. Raise hood.
2. Remove bulb holder from the hole in
the backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
• Check wiring.
See electrical wiring
diagram in the Repair Parts manual.
TO REPLACE
FUSE
Replace with 20 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
ENGINE
TO ADJUST THROTTLE
CONTROL
The throttle
control has been preset at
the factory and adjustment
should not be
necessary Check adjustment as described
below before loosening cable. If adjustment
is necessary, see engine manual.
TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be neces-
sary. If adjustment is necessary, see engine
manual.
TO ADJUST CARBURETOR
Your carburetor has been preset atthe factory
and adjustment
should not be necessary.
However, minor adjustment may be required
to compensate for differences in fuel, tem-
perature, altitude or load. If the engine does
need adjustment, see engine manual.
TRANSMISSION
REMOVAL/REPLACE=
MENT
Should your transmission require removal
for service or replacement,
it should be
purged after reinstallation and before op-
erating the tractor. See "PURGE TRANS-
MISSION" in the Operation section of this
manual.
26
Tabla de contenido
loading

Tabla de contenido