Measuring; Functions - Stanley FatMax TRU LASER TLM200 Manual De Empleo

CLEAR Key
Pushing the CLEAR/OFF - key {A, 5} clears the last
entry or measurement. Within a function (area,
volume, etc.) single measurements can be deleted
step by step and re-measured.
Illumination
The display backlight remains on for 15 seconds after
the last key press.
Reference Setting
The default reference setting is from the rear of the
instrument. By pressing the MEASUREMENT REFE-
RENCE - key {A, 6}, the setting can be changed, so
that the next measurement taken will be from the
"front" of the in-strument. Afterwards the reference
setting automatically defaults back to rear. See
picture {D}. By pressing MEASUREMENT REFERENCE
- key {A, 6} long, the reference setting will stay from
the "front" of the instrument. Repeated pressing of
the MEASUREMENT REFERENCE - key {A, 6} will set
the instrument to its default reference setting.

Measuring

Single Distance Measuring
Pressing ON/MEASURING - key {A, 1} turns the laser
on. Aim at the desired target and press ON/MEASU-
Stanley TLM 200 1.0.0 gb
RING - key {A, 1} again. The measured distance is
displayed immediately in the chosen unit.
Minimum/Maximum Measuring
This function allows the user to measure the
minimum or maximum distance from a fixed
measuring point as well as to determine spacing - see
figure {E}. It is commonly used to measure diagonal
distances (maximum values) or horizontal distances
(minimum value).
Press and hold ON/MEASURING - key {A, 1} until you
hear a beep, indicating the device is in a continuous
measuring mode. Then slowly sweep the laser back
and forth respectively up and down over the desired
target point - see figure {F, G} - (e.g. a corner in the
room).
Press ON/MEASURING - key {A, 1} again and the
continuous measurement will be stopped. The
current values for maximum and minimum distances
are shown in the display as well as the last measured
value in the main line.

Functions

Addition / Subtraction
Take the first measurement, addition is executed by
pressing the PLUS - key {A, 2} and subtraction by
pressing the MINUS - key {A, 7}, then take the next
measurement. This process can be repeated as many
times as is required. The result is displayed in the
main line, whilst the last measurement taken is also
3
GB
Measuring