AGV HORIZON SKYLINE Manual De Instrucciones página 21

5) ACCESSORIES
A sunshade screen is available for the Horizon and the Skyline. It is fitted inside, with an easy-to-use retraction
mechanism, and can be removed for cleaning or replacement without the need for tools.
5.1) Activating the sunshade screen
To activate the sunshade screen, simply use the lever positioned on the left side of the helmet level with the
visor mechanism.
1
5.2) Sunshade screen Removal/Installation
We recommend that you carry out the following operations while resting the helmet on a flat surface.
1
3
2
The sunshade screen is made of scratch-proof polycarbonate
and has connections that fit into the inner housings by the side
of the cheek pads.
2
4
3
To lower the sunshade screen,
push the lever up (1).
To retract the sunshade screen,
push the lever down (2).
To remove the sunshade screen, lower it
completely and raise the visor until it is
fully open (1). Starting from one side of
the helmet, press gently inwards on the
side of the sunshade screen and extract
the hook-up connection (2). Repeat the
operation on the other side and remove
the sunshade visor.
NB: Once you haved pulled out one
side, do not pull or force the visor
in a direction other than that of the
horizontal runner when pulling out
the other side.
To install the sunshade screen, push the
small visor lever up and ensure that the
lateral guides are in the lowered posi-
tion.
NB: The left guide is activated by the
lever on the outside of the helmet.
The right guide can be lowered manu-
ally (3).
Starting from one side of the helmet,
with the visor completely raised, insert
the sunshade screen connection into
the housing on the side of the helmet,
ensuring that it rests on the lateral
guides (4). Repeat the operation on the
other side. Check that the sunshade
screen works properly.
21 2