Daily Cleaning Operations; Cleaning The Fi Lters And Fi Lter Holders - Iberital INTENZ Manual De Instalación Y Funcionamiento

IBERITAL
2.3.4. Programming hot water (only available on New Iberital and Iberital Expression
Two models)
Enter programming mode, pressing the 'non-stop' button for 5 seconds on the group 1 button pad (left); the 'non-
stop' LED will light up.
- If the option 'NO' MIXED TEA is selected on the visual display or for machines without visual
display:
• Press the hot water button. At that moment hot water will begin to come from the boiler.
• When the desired dose has been obtained, press the hot water button again.
• The hot water setting has been programmed.
- If the option MIXED TEA is selected on the visual display or for machines without visual
display:
• Press the hot water button. At that moment mixed water (hot/cold) will begin to come from
• Press the hot water button. At that moment hot water will begin to come from the boiler.
• When the desired dose has been obtained (fi rst press + second press), press the hot water
• The fi nal hot water setting has been programmed.
NOTE (versions with visual display and miscellaneous solenoid valve): At the same time there is a manual
regulator found on the side of the water mixing solenoid valve.
2.4.- HOT WATER DISPENSER
Place the cup or any other recipient under the hot water dispenser (8). Turn the hot water knob (18) in order to
begin dispensing water and turn it back again to stop it, or press the hot water dosage button if your machine
features one.
2.5.- STEAM DISPENSER
a) Twist the steam dispenser (9) towards the tray (15).
b) Open the steam tap (7), and in order to remove condensation let the steam fl ow out until no water
droplets accompany it.
c) Position the steam dispenser (9) inside the liquid recipient you wish to heat. Turn the knob (7)
to release the steam. In order to obtain a frothy cappuccino, keep the mouth of the steam ejector
close to the surface of the milk. This will create an abundance of foam/froth.
d) When the liquid has reached the desired temperature, close the steam tap.
e) Move the recipient containing the liquid, removing the steam dispenser (9) and aiming it at the
tray (15).
f) Open the steam tap (7) for a moment, in order to remove residue stuck to the steam dispenser (9).
Clean the steam dispenser (9) with a damp cloth or sponge.

2.6.- DAILY CLEANING OPERATIONS

2.6.1. Cleaning the fi lters and fi lter holders
Rinse the fi lters and fi lter holders in hot water. Leave them in hot water overnight in order to dissolve the grease
left by the coff ee.
Page 50
the boiler.
button again.
INSTALLATION AND OPERATION MANUAL