How To Avoid Interference From Other Prontos; How To Use A Longer Connection Cable - Philips Pronto RFX6500 Guia Del Usuario

2 On the Pronto Remote Control, choose the same Extender ID for each
device controlled by the RF Extender.
Refer to the Pronto User Guide for more information.
3 Try to operate the devices with the Pronto Remote Control.
The red LED on the Blaster unit will blink when the RF Extender receives a
correct command.
Note
4 Repeat this procedure for every RF Extender.

How to Avoid Interference from Other Prontos

If the red LED on the Blaster unit is blinking without the Pronto Remote Control
sending commands, the Receiver unit picks up signals from another Pronto Remote
Control on the same channel. You can solve this problem by changing the channel.
You configure the channel on the Pronto Remote Control and on the Blaster unit.
Both channels must be the same. Four channels (CH from 0 to 3) can be assigned.
1 Choose a channel on the Blaster unit by turning the CH dial with a
small screwdriver.
2 On the Pronto Remote Control, choose the same channel.
Refer to the Pronto manual for more information.
3 Try to operate your devices with the Remote Control.

How to Use a Longer Connection Cable

When the connection cable included is not long enough to connect the Receiver
unit to the Blaster unit, you can use a longer cable (up to 20 ft / 6 m). You can
connect the Receiver unit to the Blaster unit with a standard shielded stereo audio
cable with 2.5 mm male jacks on both sides.
User Guide
13
The LED of the Receiver unit will always blink when RF signals are being
received, even when the extender ID of the Pronto Remote Control and the
Extender ID of the blaster do not match.
The LED of the Blaster unit will blink only when the configuration of the
Pronto Remote Control matches the Extender ID on the Blaster unit.
How to Do More