Cleaning Bedding; About The Sensors; Clear Dust (Clean Dust Mesh Filter) - IRIS IC-FAC2U Manual De Instrucciones

USAGE INSTRUCTIONS (CLEANING BEDDING)
1. Please spread out the bedding or mattress pad to lay flat (no folds).
2. Hold the collection head firmly in place, then lower the handle to unlock.
3. When the device is on, move back and forth every 10 seconds.
Please do not forcefully press down the collection head.

ABOUT THE SENSORS

Dust Sensor:
Dust and dust mite sensor works during use, and
light indicates the amount of dust on the surface
area.
*When cleaning carpets or other items with high
dust levels, indicator light will not turn green.
Top
Dust indicator light
Red: Not clean
Orange: Almost clean
Green: Clean
5

CLEAR DUST (CLEAN DUST MESH FILTER)

Please clear and clean regularly to maintain higher suction capabilities.
1. Remove the dust cup.
Press the buttons on either side of the dust cup to remove it.
2. Remove the mesh filter in water.
To avoid splattering of dust, please remove the mesh filter from the dust
cup in water.
3. Clean the mesh filter.
Clean the dust stuck to the filter, then rinse the filter with running water.
Soak the dust cup in water with a diluted cleaning agent for
several minutes for easy removal of accumulated dust.
4. Dry.
Place the dust cup and filter in a well ventilated area until fully dry.
*When cleaning the mesh filter set, please do not use washing machine
or other heated device as this may cause product deformation.
5. Reassemble the mesh filter.
Place the mesh filter set back into the dust cup.
*Pay attention to the direction.
Notice:
Please reassemble correctly to avoid damaging the product.
6. Reattach the dust cup.
Place the mesh filter in the dust cup, and then place the dust cup back
into the vacuum body until you hear it click into place.
Please verify that both buttons are clicked firmly in place.
Dust cup
Button Button
Dust cup
Dust cup
Button Button
6
Mesh Filter
Click!