Troubleshooting - Worx HYDROSHOT WG629 Manual De Instrucciones

TROUBLESHOOTING

Symptom
Machine turns on but
it does not draw any
water or there is not
sufficient pressure.
Multi-spray nozzle
leaks.
Outlet pressure
increases suddenly.
Machine drains out
14 14
water after stopping.
Soap accessory
cannot spray out any
detergent.
Machine does not
start.
Machine pressure is
not consistent.
Machine stops
automatically.
20V Max Lithium Portable Power Cleaner
Possible causes
Power nozzle is too high from
the water source surface.
Hose filter is blocked.
The users garden hose is not
well connected to the machine.
Hose adapter looses.
The filter screen is missing.
(See Fig. G2)
Pump, hose, or other parts
are frozen due to outside
temperatures.
Hose kinks.
The nozzle pattern does not
spray correctly.
Fixing nail of the multi-spray
nozzle loosens.
Multi-spray nozzle is blocked.
There is water remaining in the
lance and pump after stopping.
Blockage in the soap bottle.
The battery pack is not attached
well.
Battery pack is empty.
Defective battery.
Additional air could be sucked
into the machine.
It is at low pressure setting.
Battery pack is empty.
The multi-spray nozzle is
blocked. The current protection
is activated.
Solution
Lower the machine below 5ft/1.5m.
Take out the hose filter and rinse the parts with
clean water. (See Fig. S1, S2)
Check and reattach the garden hose tightly. (See
Fig. G3)
Tighten the hose adapter securely with a
spanner.
Contact WORX service agent to get a filter
screen.
Wait for the pump, hose or other parts to thaw.
Straighten out the hose.
Make sure the nozzle pattern symbol aligns
with the indicator mark on tool.
Tighten it with a hex key.
Replace with a new multi-spray nozzle.
Drain all the water completely before storage.
Clean it with fresh water.
Reinstall the battery pack.
Replace with a new battery pack or recharge the
battery pack.
Replace with a new battery pack.
Check connection between the hose adapter
and the hose.
No action need.
Replace with a new battery pack or recharge the
battery pack.
Remove the multi-spray nozzle and turn on
the machine. If the machine works normally,
replace with a new multi-spray nozzle.
EN