Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Lumination
LIS Series
®
IMPORTANT -Maximum Length of Electrical Run
IS Series
Voltage
A E, G, S or J
B, F or K
120V
192'
277V or 347V
400'
• Please see technical data sheet for electrical properties
to ensure safe installation.
• Under any circumstance, maximum driver current
through connected fixtures shall not exceed 15A for
types A, G, J, B, F, K, or E.
• Maximum drive current through connected fixtures
shall not exceed 12A for types M, N, P, R.
LIS series luminaires come in two versions: continuous units (LISC series) and independent units (LISI series).
A continuous electrical run will consist of a number of continuous units up to a maximum current specified above.
Run lengths should be based on 8ft fixtures with 4ft fixtures used only to complete a row as needed. When installing
luminaires use clean gloves in order to avoid fouling the reflective surface. To insure a clean fixture, install the fixture with the
plastic bag around the fixture, and then remove plastic bag upon completion of any and all construction related activity.
If two additional circuits are included in luminaire, they must be connected in daisy chain to the same circuit breaker as per
diagram below and total current not exceeding a maximum of 15A or 12A (per above comment).
Breaker
Daintree Node
Identification Label
2
1
1
Daintree Node identification label
installed on luminaire back reflector.
2
Remove package with smaller
label. This label is to be used for
customer floor plan or records.
Lumen Code
M, N, P or R
U, V, W or X
160'
80'
60'
320'
188'
132'
Circuit #1
Circuit #2
Installation of an Independent Unit(LISI)
1
Carefully unpack unit and inspect
for defects before installing. Wear
work gloves to prevent dirt and
oil from being transferred to the
luminaire.
NOTE: When installing luminaires use clean
gloves in order to avoid fouling the reflective
surface.
LIS Series
Voltage
[84]
120V
192'
277V or 347V
400'
• Maximum driver current through connected fixtures
shall not exceed 15A for lumen codes [42], [52], [84] or [A0].
• Maxiumum driver current through connected fixtures shall
not exceed 12A for lumen codes [65], [85], [A3], [A7], [A1],
[A2], [B1] or [B4].
4
Installation Guide
8ft Lumen Code
[A0][A2]
[A3][A7]
[B1][B4]
160'
80'
320'
188'
Choose suspension method
Choose suspension method
2
Attach mounting bracket to ceiling
support structure either directly or
using a GE suspension
kit according to the suspension
kit instructions (see page 2).
Maximum distance between
suspension points shall not exceed
the length of the luminaire.
60'
132'
Capítulos
Tabla de contenido
