Dirt Cup; Filters - Hoover WindTunnel High Capacity Upright Pet Instrucciones De Funcionamiento Y Mantenimiento

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

A Thermal Protector has been designed into your cleaner to protect it from overheating. When the
thermal protector activates the cleaner will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Empty dirt cup.
3. Inspect the nozzle inlet, hose connector, hose, dirt cup inlet, cyclonic filter, Rinsable filter,
and HEPA filter for any obstructions. Clear obstructions if present.
4. When cleaner is unplugged and motor has cooled for 30 minutes, the thermal protector will
deactivate and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner
needs servicing.

dirt cup

when to empty
4.2 To maintain optimal performance, empty the dirt cup before the dirt cup
reaches the max line, as indicated by arrow. Place the vacuum in the upright
position before removing the dirt cup.
To reduce the risk of personal injury - Unplug before cleaning or
servicing. Do not use vacuum without dirt cup or filters in place.
Very fine materials, such as face powder or cornstarch, may seal the filter
and cause a reduction in performance. When using the vacuum for this
type of dust, empty the cup and clean the filters often.
how to empty
4.3 Press dirt cup
release button (A) and
pivot cup out.
4.4 Hold dirt cup over
trash receptacle, push
dirt cup door release
lever (B) to open dirt
cup door (C).
Close dirt cup door (C).
Press firmly to secure
at front.
4.5 Place bottom of dirt cup into vacuum body first. Pivot dirt cup into vacuum
body and press firmly until it locks into place.

filters:

when to clean
To maintain optimal performance, filters should
be cleaned at least every two months under
normal use.
rinsable filter: how to clean
Remove dirt cup as described in Fig. 4.3.
4.6 Pull up on dirt cup latch (A) to open.
4.7 Pull on the fabric tab on filter to remove Rinsable
Filter.
Hold filter under running water for two minutes to
remove dirt and debris. Squeeze filter twice while
underwater. Remove from water and squeeze a
final time to remove excess water.
!
WARNING
!
4.3
NOTICE
!
4.4
A
b
To reduce the risk of personal injury - Unplug
before cleaning or servicing. Do not use
vacuum without dirt cup or filters in place.
4.6
9
Actual model may vary from images shown.
!
4.2
4.5
C
WARNING
!
4.7
A
A
!
b

Capítulos

Tabla de contenido
loading

Tabla de contenido