Idiomas disponibles
Idiomas disponibles
Kentau
200x200mm
225
KENTAU SQ 20W
Ø200mm
225
KENTAU CL 20W
IP40
INSTALLED
IP20
120º
180-250ac
LUMINAIRE
BEFORE INSTALLING THIS PRODUCT, PLEASE READ THE INSTRUCTIONS CAREFULLY AND STORE THEM IN A SAFE PLACE.
THE INSTALLATION SHOULD BE CARRIED OUT BY PROFESSIONAL INSTALLATORS.
INCORRECT HANDLING OF THE PARTS OR THE LIGHT FIXTURE ITSELF MAY IMPAIR THE PROPER PERFORMANCE OF THIS PRODUCT. IN THIS CASE,
THE MANUFACTURER GUARANTEE SHALL BE DEEMED VOID.
THE MANUFACTURER GUARANTEE SHALL BE DEEMED VOID: IF THE INSTALLATION IS NOT PERFORMED IN ACCORDANCE WITH THE SPANISH LOW
VOLTAGE ELECTROTECHNICAL REGULATION (REBT 2002) RD 842/2002, EUROPEAN DIRECTIVE 98/34/CEE, DIRECTIVE 73/23.
PRECAUTIONS:
• Keep product out of the reach of children.
• Do not immerse this device in water or handle it with wet hands.
• Do not use gloves or any plastic material.
• Be careful not to bang the device.
• Do not install the product in the presence of heat sources or high
concentration of moisture.
• Do not handle the product whilst it is in use and allow it to cool down before
hand contact.
• Maintain a minimum distance of 1m between the device and the nearer
surface or object.
• Not suitable for bathroom use.
• Under no circumstances should the screen be covered with thermal
insulation material.
• If the device is faulty, replace immediately with a new one.
• Disconnect current before installing device.
• Handle the light fixture by holding the body, never the diffuser, as it may
collapse and damage the light source (LED).
• A discharge on this light fixture may destroy or damage its electrostatic
sensitive components.
1/4
febrero 2020
150x150mm
175
KENTAU SQ 14W
Ø150mm
175
KENTAU CL 14W
>80
>50.000h
REMARKS
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
125x125mm
150
KENTAU SQ 9W
Ø125mm
150
KENTAU CL 9W
ASSEMBLY INSTRUCTIONS:
1. Make a hole in the mounting surface, ensuring the diameter of the hole
corresponds to each size of device (See table).
2. Disconnect power.
3. Open the driver's cap (FIG.1).
4. Lift the three flaps along with the wire clip (FIG.2).
5. Insert the power cord as requiered (SEE CONNECTION DIAGRAM).
6. Using the supplied screws, fix the clip to the device to make sure
the cable is kept in the right position.
7. Close the driver downline cap.
8. Insert the driver into the installation hole.
9. Tilt the fastening springs and insert the light fixture into the ceiling.
10. Reconnect electric current.
REPLACING THE LAMP:
• Non-replaceable lamp.
REPLACING THE DRIVER:
1. Disconnect power.
2. Remove light fixture.
3. Replace the gear for a new one. Follow the previous instructions for wiring
driver.
4. Return the light fixture to the installation hole.
5. Reconnect power.
100x100mm
125
KENTAU SQ 6W
Ø100mm
125
KENTAU CL 6W
