Empire Heating Systems SR-6-3 Instrucciones De Instalación Y Manual Del Propietario página 11

1 3/32"
(28mm)
OUTLINE OF
OUTER CASING
18 7/8"
(479mm)
2 1/32" (52mm)
4 1/32" MIN
(102mm)
MOUNTING HOLE LOCATIONS
VIEWED FROM FRONT OF HEATER
Figure 11 (SR-18)
2"
(51)
1 3/32"
(28mm)
18 7/8"
(479mm)
4 1/32"
2 1/32" (52mm)
(102mm)
MIN
Figure 12 (SR-30)
16942-9-0314
WALL MOUNT INSTALLATION (CONT.)
18"
(457mm)
14"
(356mm)
2" MIN (51mm)
FLOOR
24 1/8"
(613mm)
2"
20 1/8"
(51)
(511mm)
(559mm)
2" (51mm)MIN
On Solid Wall
1. After locating mounting holes, attach (4) #10 x 1" (25mm) screws
provided into the wall. Do not completely tighten screwheads
to the wall, leave a 1/8" (3mm) gap between screwheads and
wall.
2. Mount heater onto the (4) screwheads and complete tightening
screwheads into the wall.
Attention! Use the following steps to properly align the upper
louver and the reflector with the heat shield.
a. When replacing upper louver, be sure the bottom lip of upper
louver goes behind the heat shield.
b. When replacing reflector, be sure the top lip of reflector
goes in front of the heat shield.
3. Connect the gas line.
22"
(559mm)
On Sheet Rock Wall
1. After locating mounting holes, drill (4) 5/16" (8mm) diameter
holes into the wall.
2. Insert (4) plastic expansion anchors provided into the holes.
3. Tighten (4) #10 x 1" (25mm) screws provided into the plastic
expansion anchors. Do not completely tighten screwheads to
the plastic expansion anchors, leave a 1/8" (3mm) gap between
screwheads and plastic expansion anchors.
4. Mount heater onto the (4) screwheads and complete tightening
the screwheads to the plastic expansion anchors.
Attention! Use the following steps to properly align the upper
louver and the reflector with the heat shield.
a. When replacing upper louver, be sure the bottom lip of upper
louver goes behind the heat shield.
b. When replacing reflector, be sure the top lip of reflector
goes in front of the heat shield.
5. Connect the gas line.
22"
Figure 13
Page 11