One-Piece Doors - Craftsman 139.5398511 Manual Del Propietário

ONE-PIECE DOORS
Please read and comply with the warnings and
reinforcement instructions on the previous page.
They apply to one-piece doors also.
• Center the door bracket on the top of the door, in
line with the header bracket as shown. Mark either
the left and right, or the top and bottom holes.
• Drill 5/16" pilot holes and fasten the bracket with
hardware supplied.
If the door has no exposed framing, drill 3/16" pilot
holes and fasten the bracket with 5/16"x1-1/2" lag
screws (not provided) to the top of the door.
NOTE: The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
Drill 3/16" pilot holes and substitute 5/16"xl- 1/2" lag
screws (not provided) to fasten the bracket to the
door.
HARDWARE SHOWN ACTUAL SIZE
© ©
Nut 5/16"-18 LockWasher 5/t6"
Carriage Bolt
5/16"q 8x2-1/2"
Header Wall
2x4
Header
Bracket
Optional
Placement
of Door
Bracket
Finished Ceiling
Door
Bracket
Vertical
Centarline
of Garage
Door
Horizontal and vertical
reinforcement is needed for
.=dOOrS
(fiberglass, aluminum, steel,
door with glass panel, etc.).
(Not Provided)
For a door with no exposed framing,
or for the optional installation, use
5/16"xt-t/2" lag screws (Not provided)
to fasten door bracket.
®
_Lock Washer
' 5/16"
i
i
I ' Top of Door
/ (inside Garage
_ h TopEdge /"
_,_ 5 °f D°°r
J,) opt,ooa,
/_ _'_ Placement
_Carriage Bolt
5/16 "_18x2-1/2"
24