Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Preparing
your
garage
door
Before you begin:
• Disable locks
• Remove any ropes connected to garage door
• Complete
the following
test to make sure your
garage door is balanced and is not sticking or
binding:
1 Lift the door about halfway as shown. Release
the door. If balanced, it should stay in place,
supported entirely by its springs.
2 Raise and lower the door to see if there is any
binding or sticking
If your door binds, sticks, or is out of balance, call a
trained door systems technician.
Sectional Door
To prevent possibleSERIOUSINJURY or DEATH:
• ALWAYScall a trained door systems technician if
garage door binds, sticks, or is out of balance.An
unbalancedgarage door may not reverse when
required
• NEVERtry to loosen, move or adjust garage door, door
springs, cables, pulleys, brackets or their hardware, all
of which are under EXTREME tension.
• Disable ALL locks and remove ALL ropes connected to
garage door BEFORE installing and operating garage
door opener to avoid entanglement.
To prevent damage to garage door and opener:
• ALWAYSdisable locks BEFORE installing and operating
the opener.
• ONLYoperate garage door opener at 120V,60 Hz to
avoid malfunction and damage
One-Piece Door
Tools
needed
During assembly, installation and adjustment of the
opener, instructions will call for hand tools as
illustrated below.
Carpenter's
_
_1
_
J_
\;_
Level (optional)
_
_
Hack Raw
°_
_1
Tape Measure
_
f_
--
-
_
Wire Cutters
/
";""_
_
Claw Hammer
Drill Bits
_k_
and 5/32"
Pliers
Screwdriver
O0
o
Stepladder
U
e c
_
_
v
1/2,6/8,7/16,9/16
Locking pl_ers
Adlustable
End Wrench
and 1/4"
3
Capítulos
Tabla de contenido
