Maintenance; Cleaning The Filter - Royal Sovereign ARP-7010 El Manual Del Propietario

MAINTENANCE

Occasionally, you may need to drain the unit. The Water Full light will light up on the LED display when draining is necessary.
To drain:
1. Turn off the power to the unit and unplug.
2. Place a container to catch the water under the drainage port to collect water.
3. Remove the rubber drainage plug.
4. Replace the plug, when drainage water stops flowing.
For continuous drainage into a floor drain:
1. Turn off the power to the unit and unplug.
2. Remove the rubber drainage plug from the drainage port.
3. Attach a drainage hose (not included) to the drainage port.
4. Place other end of drainage hose into a floor drain.
5. Replace the rubber drainage plug after operation to prevent leaks.

Cleaning the filter

The filter should be cleaned about every 2 weeks to maintain proper airflow.
1. Turn off the power to the unit.
2. Looking at the back of the unit locate the 2 filters on the right hand side.
3. Slowly pull out both filters.
4. Filter can be cleaned by a vacuum or soft cloth.
If the filter is very dirty it can be washed with a mild detergent and rinsed with water.
Make sure filter is dry before replacement.
5. Insert both filters back into the unit.
Note: Never run the unit without the filter in. This could damage the unit.
ARP-7010, ARP-7013, ARP-7013H
11