Manually Setting Radio Type; Remapping The Swc Buttons - Axxess FRST-2 Instrucciones De Instalación

Manually setting radio type:
If the LED flashes do not match the radio connected you must then manually program the
ASWC to tell it what radio it is supposed to be connected to.
To manually program the aftermarket radio:
1. Turn on the ignition. Then press and hold the "Volume Down" button on the steering
wheel control until the LED goes solid red and then release the "Volume Down" button.
2.
Using the listing below press the "Volume Up" button the number of times
(number is to the left of the radio name) needed to program the correct radio type
to the ASWC:
3. Press and hold the "Volume Down" button for 5 seconds to finish programming.
The LED will then go off.
4. After a few seconds, the LED will then blink the number of times corresponding
to the radio type. Verify that the number of blinks are the same number of times the
"Volume Up" button had been pressed.

Remapping the SWC buttons

Let's say you have the FRST-2 programmed to your vehicle and your radio and you want to
change the button assignment for the steering wheel controls. For instance, if you would like
the "Seek Up" button to be assigned as "Mute".
Continued on next page
FRST-2
Programming SWC
1
Eclipse
2 Kenwood
3
Clarion
4
Sony Dual
5
JVC
6
Jensen/Pioneer
7
Alpine
8 Visteon
9
Valor
10 Clarion 5K
11 Metra OE
7