Lea LE20055 DN Instrucciones Originales página 17

Do not cut against hard objects. This could cause injury or damage the trimmer.
Do not use the trimmer to cut grass which is not in contact with the ground, for example,
do not cut grass which is on walls or rocks etc.
7. ASSEMBLY
The trimmer is supplied with some components which need to be assembled. Please proceed
as follows:
7.1 Safety guard assembly
Insert the wheel bracket(12) onto the motor housing and turn it counterclockwise.(Fig.2)
Insert the safety guard (11) onto the wheel bracket and secure it with 4 screws.(Fig.3)
7.2 Auxiliary handle assembly
Press the locking button(4) and hold, and then assemble the Auxiliary handle;(Fig.4)
Secure it with the one screw supplied.(Fig.5)
If the operator want to adjust the handle position, do the step as following: (Fig.6)
a. please press the locking button(4) and then rotate the
b. until the button clicks securely into locked position to a comfortable working
height, and then release it.
8. OPERATION
8.1 Starting
To switch on the trimmer first press the On/Off trigger (2). To switch off simply release the
On/Off switch trigger(2)
If you find that the nylon line is too short, let the trimmer run for a few seconds without
touching the working area to allow the trimmer to cut the line after it lengthens.
Do not overload the trimmer, cut in small sections which will greatly improve efficiency by
keeping the trimmer running at high speed.
8.2 Adjust the telescopic length (Fig.7)
Make sure the height of the trimmer is in the most comfortable position before use. Adjust the
height as follows:
Loosen the
adjusting knob
Pull/push the tubes to a comfortable length
Tighten the
adjusting knob
8.3 Adjust the cutting angle (Fig.8)
Press the rotation knob.
Push the Rotating knob(7) and then rotate the shaft to a comfortable position and release
the button as you hear the 'click' sound. Totally has 3 levers.
Release the rotation knob when you get the desired stage.
9. USING THE TRIMMER AS AN EDGER
For edging driveways and paths, transform the trimmer from trimmer mode to edging mode as
follows:
In order to use the grass trimmer as an edge cutter, use the settings as follows:
(5)
(5)
14
Auxiliary
handle(3),