Roav Pro 100A Manual Del Usuario página 6

2. Plug in the jumper cables. The LED display on the jump cables
should show circulating clockwise.
3. Connect the red clamp to the positive terminal (+) and the black
clamp to the negative terminal (-) of your car battery.
4. Start your engine. The cables' LED display should show the current
voltage of the jump starter battery.
07 English
The jump starter will halt power output after eight
consecutive attempts to jump start the car engine, and
will flash on the LED display.
5. After successfully jump starting your car, unplug the jumper
cables within 30 seconds.
• After every successful jump start, the jump starter will reset
automatically. If it fails to jump start your car, remove and
reconnect the clamps after two minutes. After the LED
display shows the voltage, start the car engine.
• DO NOT charge the device immediately after jump starting
your car. Wait at least 30 minutes before charging the
device after a jump start.
• DO NOT crank the engine for more than 3 seconds. Allow
the jump starter to cool down for at least 1 minute after
each attempt.
• If it is extremely hot or cold, wait for several minutes until
the battery works properly (0-60°C).
English 08