Start Time - KENMORE ELITE 625.385200 Manual De Uso Y Cuidado

SETWATERHARDNESS NUMBER
If you completed the previous step, the word "HARD-
NESS" should show in the display. Otherwise, press the
SELECT button several times until it does.
SALT SIGNAL
LEVEL LEVEL
8
7
6
5
4
3
2
1
_C
G_
HARDNESS
Figure 18
1. Press the f UP or V DOWN buttons to set the
hardness of your water supply, in grains per gallon.
The default is 25.
NOTE: If your water supply contains iron, compensate
for it by adding to the water hardness number.
For example, assume your water is 20 gpg hard
and contains 2 ppm iron. Add 5 to the hardness
number for each 1 ppm of iron. In this example,
you would use 30 for your hardness number.
2ppmironx5-- 10
(times)
20 gpg hardness
+10
30 HARDNESS NUMBER
If your water supply contains iron, it is recom-
mended that you clean your water softener resin
bed at least every 6 months. Your local Sears
store has Water Softener Cleaner (Part Number
34427) available.
2. When finished setting your water's hardness number,
press the SELECT button, and the display will change
to show the "Recharge Time" screen.
SET RECHARGE (REGENERATION) START TIME
If you completed the previous step, the words "RE-
CHARGE TIME" should show in the display. Otherwise,
press the SELECT button several times until they do.
SALT SIGNAL
LEVEL LEVEL
8
7
6
5
4
3
2
1
TI,Fl FI AM
C'uu
RECHARGE
TIME
Figure 19
.
The softener's default recharge start time is 2:00 AM.
This is normally a time of day when water is not
being used in the household. Hard water bypasses
the softener if the household draws water during the
recharge cycle. If a different recharge start time is
desired, press the f UP or V DOWN buttons to
change the time, in 1-hour increments. Be sure AM or
PM is correct.
When the desired recharge start time is displayed,
press the SELECT button, and the display will change
to show one of the "Salt Type" screens shown below.
SALT SIGNAL
LEVEL LEVEL
8
7
6
5
4
3
2
1
SALT SIGNAL
LEVEL LEVEL
8
7
6
5
4
3
2
I
F'J
NCl
Figure 20
SET SALT TYPE
If you completed the previous step, either "NaCI" (for
Sodium Chloride) or "KCI" (for Potassium Chloride)
should show in the display. Otherwise, press the
SELECT button several times until one of them does.
1. Press the f UP or V DOWN buttons to set the type
of salt you will be using in your water softener. The
default is NaCI (standard Sodium Chloride water sof-
tener salt). If you will be using I<CI (Potassium
Chloride) instead, be sure to set salt type to KCI. This
setting adjusts the regeneration cycle times to com-
pensate for the different rate at which KCI dissolves.
See also the following page for more information on
salt types.
2. When the correct salt type is displayed, press the
SELECT button, and the display will return to the nor-
mal run (time of day) screen.
SALT SIGNAL
LEVEL LEVEL
8 OFF
7
6
5
4
3
2
1
Figure 21
Questions? Call the Kenmore Water Line 1-800-426-9345 or visit www.kenmorewater.com
14