Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3. Installation
3.5 Installation Within Row
Note: Follow the instructions in this section only if the SRCABLELADDER18 accessory will be installed within a row of enclosures. If the SRCABLELADDER18
accessory will be installed across an aisle, follow the instructions in Section 3.4 Installation Across Aisle instead.
1
Insert four assembly brackets
hooked end first. When the ladder is oriented so that the ladder's
rungs are above the ladder's side rails, the hooked ends of the
brackets should point down, as shown in the drawing.
2
Align the pin holes in the ladder sections with the pin holes in
the assembly brackets and insert clevis pins
holes (4 total). This step may be omitted to provide additional
installation flexibility, but installing the pins will make the
SRCABLELADDER18 accessory more stable.
Warning: If you choose not to install the clevis pins, make
sure at least 25% of the length of each assembly bracket is
inside the ladder.
3
After inserting the clevis pins, insert a cotter pin
hole at the end of each clevis pin. (The straight section of the
cotter pin goes through the hole.)
4
Using an assistant, lift the SRCABLELADDER18 accessory (rungs
upward) and align the holes at the ends of the assembly brackets
D
with the corresponding holes
accessories installed at the top of each enclosure.
Note: There are two levels of holes. Use the holes that match your
application best.
5
Align the pin holes and insert clevis pins
holes (4 total).
A
in the open ends of the ladder,
B
into the pin
C
through the
E
in the SRCABLETRAY
F
into each of the pin
A
1
B
2
3
4
5
6
A
C
E
D
F
B
Capítulos
Tabla de contenido
