Presentación; Descripción - StetSom SX2 Manual De Instrucciones

NOTE: Repeat steps 1 through 3 to synchronize more than one transmitter (maxi-
mum 8). If more than 8 transmitters are synchronized, the newest transmitter will
override the synchronization of the oldest one.
– To desynchronize a single transmitter:
1. Press the SYNC button (16) on the RX2 Light receiver. The LED indicator (18) will
flash.
2. Press the MEM key (17) on the RX2 Light receiver. The LED indicator (18) will blink
faster and turn off. All transmitters have been deleted.
– Restoring Factory Settings:
Hold the SYNC/RESET key (16) down for 5 seconds. The LED indicator (18) will
flash and the factory settings will be restored. The synchronization of the TX2 Light
transmitters will be maintained.
• Diagnosing a Problem:
– Indications of a weak battery:
When the TX2 Light transmitter's key is released, the transmission indicator LED
(01) and the receiver's LED indicator (18) will remain on for 1 second. We recommend
that you replace the battery with a new one, model CR2032, since the transmitter's
efficiency will decrease.
The TX2 Light transmitter turns itself off if any key is pressed for more than 10 seconds
to avoid draining the battery. When you release the key, the system will return to normal.
– Changing the battery of the TX2 Light Transmitter:
Remove the Holster, loosen the two screws on the back and remove the circuit
board from its plastic housing. Replace the old battery with a new one being careful to
maintain the correct polarity; the Clip must be in contact with the POSITIVE terminal of
the battery.
• Techinical Specifications:
Power Source:
Receiver: 5 a 16V DC
Transmitter: CR2032 Battery (3V)
Maximum Current Consumption:
Receiver: 30mA
Transmitter: 15mA
Dimensions:
Receiver: 10,0 x 25,0 x 55,0 mm
Transmitter: 16,5 x 39,0 x 74,0 mm
Weight:
Receiver: 39g
Transmitter: 27g
ESPAÑOL
• Presentación:
El SX2 Light fue desarrollado para comandar equipos de audio y video a larga
distancia. Debido a su tecnología de radio frecuencia (RF), es posible controlas tu equipo
de música hasta 200m de distancia en área abierta.
Su transmisión se hace en FSK, lo que reduce interferencias externas. Su código es
encriptado y con tecnología de código rotativo que impide su clonaje.
• Descripción:
1
2
3 7
4 8
5 9
6
10
11
1 LED indicador de transmisión
2 Power
PULSAR LARGO: Función Encendido/Apagado.
CLIC RÁPIDO: 1º Paso el Bloqueo de Teclas.
3 Avanzar ()
4 Retroceder ()
5 Sube Carpeta ()
6 Baja Carpeta ()
12 13
7 Volumen (+)
8 Volumen (–)
9 Play/Pause ( )
Atenuación (ATT–)
10
Manija para collar.
11
Acabamiento Protector
12
Collar
13