Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Displays and functions
Teach-in process
1.
Set the Secvest to "teach-in mode" (see installation instructions for wireless
alarm system) and send a teach-in signal from the wireless control panel to the
wireless alarm system.
2.
The teach-in signal can be sent either by inserting the batteries or by activating
the tamper switch.
3.
Once the teach-in signal has been picked up by the wireless alarm system, it
will emit two beeps and the incoming signal strength will be displayed.
4.
Confirm the successfully completed teach-in on the control panel.
operation
If the user code is entered incorrectly three times, the control panel
keypad will flash and will be locked for 5 minutes.
You can cancel incorrect code entries by pressing the star key
(see adjacent figure).
Installation and start-up
EN 17
Capítulos
Tabla de contenido
