Enclosure Configuration; Door Locks; Cable Access And Management; Reversing The Enclosure - Tripp-Lite SmartRack SRW Serie Manual Del Propietário

5. Enclosure Configuration

Before installation, be sure to plan the location and arrangement of components within the enclosure. Be sure all mounting rails are reversed or
adjusted for depth, depending on your equipment configuration.

5.1 Door Locks

The front and back doors have locks that are accessible by the included keys.
Each side panel locks using an L-shaped lever on the inside of the enclosure.
To unlock and remove the side panels, lift the shorter leg of the "L" up
1
and remove it from the enclosure.
To re-lock the side panels, secure it in the proper position, lift the shorter leg of the "L" up
2
B
that it was in initially . Once it is in place, push the shorter leg of the "L" down to lock it. Note: To lock and unlock the side panels, you will need
to have access to the interior of the enclosure.

5.2 Cable Access and Management

The back door of the enclosure has a square opening for cable access and management. An
additonal opening can be found on top of the main cabinet. Each opening can also be closed by
screwing in the removable cable access panels.

5.3 Reversing the Enclosure

In order to accommodate various rack configurations, the enclosure can be reversed. To do so, simply turn the enclosure over so that the doors open
in the opposite direction.
A
and pull it away from the side panel
A
1
4
B
. Pull the tab on the side panel
A
and push it toward the side panel, back into the hole
A
B
B
2