Using The Microphone; Troubleshooting - auna Streetstar Retro 50 Manual De Instrucciones

DSP digital effect adjust (19)
This DSP digital effect contains "REVERB", "DELAY", "TREMOLO",
"FLANGER", "CHORUS" and "PHASER" effects.
BT Pairing:
Press mode button until you see "BLUE" in the display. Check in your smart
phone the device name: [Streetstar Retro 50] and link it.

USING THE MICROPHONE

Open the battery compartment cover at the bottom of the microphone.
Insert the battery, observing the polarity. Set all volume controls to a
minimum. Turn the system on so that the power LED is lit. Turn on the
microphone and set the volume controls to the desired position.
Keep the microphone about 5-10 cm from your mouth. Pay attention to the
microphone feedback (whistle sound). Reduce the treble signal strength. If
the problem persists, reduce the volume or move the audio system. Do not
hold the microphone too close to the speaker.

TROUBLESHOOTING

If the device does not operate:
• Check the main supply connection.
• Check the battery level.
• Check the level control of each input source and the integrity of the
audio signal.
Noises or Hum:
• In Bluetooth mode, take into account the distance between the emitter
and the amplifier as well as the obstacles between them.
• Reduce the output volume to eliminate the distortion or move the tone
controls to the central position to avoid high levels.
EN
17