EN
In this part sheet, the words WARNING, CAUTION and NOTE are used to
emphasize important safety information as follows:
WARNING
!
Hazards or unsafe practices which
could result in severe personal
injury, death or substantial property
damage.
Read the following warnings before using this equipment.
READ THE MANUAL
Before operating finishing equipment, read and
understand all safety, operation and maintenance
information provided in the operation manual.
WEAR SAFETY GLASSES
Failure to wear safety glasses with side shields could
result in serious eye injury or blindness.
DE-ENERGIZE, DEPRESSURIZE, DISCONNECT AND
LOCK OUT ALL POWER SOURCES DURING
MAINTENANCE
Failure to De-energize, disconnect and lock out all power
supplies before performing equipment maintenance could
cause serious injury or death.
OPERATOR TRAINING
All personnel must be trained before operating finishing
equipment.
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture,
malfunction, or start unexpectedly and result in serious
injury.
KEEP EQUIPMENT GUARDS IN PLACE
Do not operate the equipment if the safety devices have
been removed.
PROJECTILE HAZARD
You may be injured by venting liquids or gases that are
released under pressure, or flying debris.
PINCH POINT HAZARD
Moving parts can crush and cut. Pinch points are basically
any areas where there are moving parts.
PACEMAKER WARNING
You are in the presence of magnetic fields which may
interfere with the operation of certain pacemakers.
AUTOMATIC EQUIPMENT
Automatic equipment may start suddenly without
warning.
IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PROVIDE THIS INFORMATION TO THE OPERATOR OF THE EQUIPMENT.
FOR FURTHER SAFETY INFORMATION REGARDING THIS EQUIPMENT, SEE THE GENERAL EQUIPMENT SAFETY BOOKLET (77-5300).
CAUTION
!
Hazards or unsafe practices which
could result in minor personal injury,
product or property damage.
WARNING
!
Binks reserves the right to modify equipment specification without prior notice.
2 / 12
NOTE
Important installation, operation or
maintenance information.
INSPECT THE EQUIPMENT DAILY
Inspect the equipment for worn or broken parts on a
daily basis. Do not operate the equipment if you are
uncertain about its condition.
NEVER MODIFY THE EQUIPMENT
Do not modify the equipment unless the manufacturer
provides written approval.
KNOW WHERE AND HOW TO SHUT OFF THE
EQUIPMENT IN CASE OF AN EMERGENCY
PRESSURE RELIEF PROCEDURE
Always follow the pressure relief procedure in the
equipment instruction manual.
NOISE HAZARD
You may be injured by loud noise. Hearing protection
may be required when using this equipment.
HIGH PRESSURE CONSIDERATION
High pressure can cause serious injury. Relieve all
pressure before servicing. Spray from the spray gun, hose
leaks, or ruptured components can inject fluid into your
body and cause extremely serious injury.
STATIC CHARGE
Fluid may develop a static charge that must be dissipated
through proper grounding of the equipment, objects to be
sprayed and all other electrically conductive objects in the
dispensing area. Improper grounding or sparks can cause a
hazardous condition and result in fire, explosion or electric
shock and other serious injury.
PROP 65 WARNING
WARNING: This product contains chemicals known to
the State of California to cause cancer and birth
defects or other reproductive harm.
77-3040-R1.2 (10/2014)