Changing.the.transmitter.address; Changing.the.maximum.station.number - Hunter ICR Manual Del Propietario E Instrucciones De Instalación

cHanging THe TransmiTTer address ..................................................
Both.the.ICR.Transmitter.and.Receiver.have.an."address".
that.they.use.when.communicating..If.the.addresses.do.
not.match,.the.Receiver.will.ignore.the.transmission..Your.
ICR.comes.from.the.factory.with.both.the.transmitter.and.
Receiver.address.set.to.0..You.may.change.the.address.to.
any.value.from.0-127.for.added.security..Note.that.if.you.
change.the.Transmitter.address,.the.Receiver.must."learn".
the.new.address.as.described.in.the."Preparing.the.Receiver.
for.Use".section.
To change the Transmitter address:
1.. If.the.unit.is.OFF.(no.display),.power.the.Transmitter.up.
by.pressing.any.of.the.buttons.for.at.least.1.second.then.
releasing.the.button..The.Transmitter.will.illuminate.the.
active.station.
cHanging THe maximum number of sTaTions .................................
Your.ICR.Transmitter.comes.from.the.factory.with.the.
maximum.number.of.stations.set.to.9..This.means.that.when.
you.use.the. .or. .buttons.to.change.the.station,.you.
may.change.it.to.any.number.between.1.and.9..However,.if.
you.have.controllers.with.more.than.9.stations.you.will.want.
to.increase.the.maximum.number.of.stations.

2.. Press.the.Mode.button.until.the.word."Address".appears.
on.the.display..The.address.will.be.blinking.at.this.point..
If.more.than.5.seconds.go.by.
without.a.button.being.pressed,.
the.Transmitter.will.revert.back.to.
displaying.the.active.station.
3.. Use.the.
.or.
.button.to.
change.the.address.to.any.value.
between.0.and.127..Then.do.not.
touch.any.of.the.buttons.for.5.seconds.and.the.display.
will.stop.blinking.and.return.back.to.the.active.station.
To change the Maximum Number of Stations:
1.. If.the.unit.is.OFF.(no.display),.power.the.Transmitter.up.
by.pressing.any.of.the.buttons.for.at.least.1.second.then.
releasing.the.button..The.Transmitter.will.illuminate.the.
active.station.