Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TO REPLACE FUSE
Replace
with 30 amp automotive-type
plug-
in fuse.
The
fuse
holder
is located
behind
the dash.
TO REMOVE
HOOD
AND
GRILLAS-
SEMBLY
1.
Raise hood.
2.
Unsnap
headlight
wire connector.
3.
Stand
in front of tractor.
Grasp
hood at
sides, tilttoward
engine and lift offoftractor.
4.
When
replacing
hood,
be sure to re-
connect
the headlight
wire connector.
Headlight Wire
Connector
ENGINE
Maintenance,
repair,
or replacement
of
the emission
control
devices
and systems,
which
are being done at the customers
ex-
pense,
may be performed
by any non-road
engine
repair
establishment
or individual.
Warranty
repairs
must be performed
by an
authorized
engine
manufacturer's
service
outlet.
TO ADJUST
THROTTLE
CONTROL
CABLE
The throttle
control
has been
preset
at the
factory
and adjustment
should
not be nec-
essary.
Check
adjustment
as described
below
before
loosening
cable.
If adjust-
ment is necessary,
proceed
as follows:
1.
With engine
not running,
move throttle
control
lever
to fast position.
2.
Check
that swivel
is against
stop.
If it is
not, loosen
cable
clamp
screw
and pull
cable
back until swivel
is against
stop.
Tighten
cable
clamp
screw
securely.
TO ADJUSTCHOKECONTROL
The choke
control
has been preset
at the
factory
and adjustment
should
not be nec-
essary.
Check
adjustment
as described
below
before
loosening
cable.
If adjust-
ment is necessary,
proceed
as follows:
1. With engine
not running,
move
choke
control
(located
on dash
panel)
to full
choke
position.
2.
Loosen
knob and remove
cover
as-
sembly
from air cleaner.
3.
Choke
should
be closed.
If it is not,
loosen
casing
clamp
screw
and move
choke
cable
until choke
is completely
closed.
Tighten
casing
clamp
screw
securely.
4.
Replace
air cleaner
cover
assembly
and tighten
knob.
TO ADJUST
CARBURETOR
Your carburetor
is not adjustable.
If your
engine
does
not operate
properly
due to
suspected
carburetor
problems,
take your
tractor
to a Sears
or other
qualified
service
center
for repair and/or
adjustment.
High speed
stop is factory
adjusted.
Do
not adjust
- damage
may result.
IMPORTANT:
Never
tamper
with the
engine
governor,
which
is factory
set
for proper
engine
speed.
Overspeed-
ing the engine
above
the factory
high
speed
setting
can be dangerous.
If you
think the engine-governed
high speed
needs
adjusting,
contact
a Sears
or other
qualified
service
center,
which
has proper
equipment
and experience
to make any
necessary
adjustments.
Swivel
Clamp
Screw
Clamp Scre_
25
Tabla de contenido
