Gs3105-Ba, Gs3125-Ba Or Gs3100-Bx - DSC GS3125 Manual De Instrucciones

9. Checking Signal Strenght :
– make sure that at least one of the green LEDs remains lit; all green LEDs lit indicates optimal coverage;
– if the green LEDs are not illuminated, the signal strength is TOO WEAK; change the position of the antenna until you
find a position which offers acceptable signal strength, at least one LED illuminated.
10. Close the control panel cover.
     Connect power circuit only after the cabinet has been secured to the building or structure and has been
connected to the protective earth ground of the building.
! ! ! ! ! Before inserting or removing the SIM card, please ensure the unit is powered down.
ANT-EU Remote antenna
For details of how to fit the ANT-EU remote antenna, please refer to the instructions supplied with the product. The ANT-EU
is used to provide the Communicator a excellent GSM signal strength.

GS3105-BA, GS3125-BA or GS3100-BX

See figure 1.
1. Mark the position of the holes [19] required to fix the metal base [17] to the wall.
2. Drill holes in the wall as marked.
3. Insert the 4 P.C.B. supports [16] into the holes on the metal base [27].
4. Feed the connection cables through the opening on the base [22].
5. Fix the metal base to the wall using wall anchors (not supplied).
! ! ! ! ! Make sure you do not damage wiring or pipes in the chase.
6. Position the electronic P.C.B. (not supplied with the GS3100-BX) on the supports [16] and push it down until it clicks into
position, as illustrated in Figure 1.
7. Connect the antenna cable [3] to the connector on the electronic P.C.B. [4].
8. Feed the antenna cable [3] the cable
clamp tab [26], then through the
opening [23].
9. Position the antenna [1] on the upper
edge of the base so that the magnetic
base [2] adheres to the surface.
     The antenna may be positioned
on the top edge of the base, at
the point most suited to receiving
the GSM signal.
10. If necessary, fit the MAXIASNC
anti-tamper switch [15] (opzional)
to the pins as illustrated in Figure 1.
     The switch lever must be directed
as illustrated in Figure 1,
otherwise the device will not
work correctly.
11. Perform the terminal block connections
[10] as described in par. "Connecting
the device" and, if necessary,
connect the anti-tamper switch (for
connecting the tamper switch see
the"Connecting the
>Auxiliary connections" section).
Fig. 2 - Fitting the Communicator
board inside the control panel.
GS3125/GS3105
device-
a)
1 5
6 9
G G G
G G
55