Carmen NC2110 Manual De Instrucciones página 5

THE UNIT IS INTENDED FOR HOUSEHOLD
USE ONLY BEFORE THE FIRST USE
In case of unit transportation or storage at low temperature
it is necessary to keep it for at least two hours at room
temperature before switching on.
- Unpack the unit and remove any stickers that can prevent
unit operation.
- Clean the unit body (1) with a soft, slightly damp cloth and
then wipe dry.
- Rub the attachments (8-14) with medical alcohol to
disinfect them.
> USAGE
- Insert one of the attachments (8-14) into the motor unit (1).
- If necessary, install the safety cover (2) on the unit body.
- Insert the power adapter (15) connector into the socket (6).
- Insert the power adapter (15) into the mains socket, a
sound signal will be heard and the indicator of the touch
button (5) will blink red and green.
- Switch the unit on by pressing the button (7) «0/I», the
indicator of the button (5) will light constantly, the buttons
(4) «-»/«+» illumination will light up, the LED illumination
(3) will light up, the unit will be switched on and will start
operating at medium speed.
- Touch the buttons (4) «-» and «+» to adjust attachment
rotation speed.
- After setting the required attachment rotation speed you
can block the touch buttons (4, 5) by pressing and holding
the on/off button «0/I» (7) for 2 seconds, the buttons (4)
illumination brightness will be reduced.
- To unblock the buttons (4, 5) press the on/off button «0/I»
(7), the unit will be switched off.
- Switch the unit on again as described above.
Note:
• Every touch of the touch buttons is accompanied by a
sound signal and blinking of the button (5) .
• Two sound signals indicate that the minimal or maximal
rotation speed was set.
• We recommend to use the low rotation speed for nails
ENGLISH • 5