Brother P-touch 1900 Guía De Usuario página 57

Error Message
LENGTH • This message appears if the text is
LIMIT!
• This message appears if the Length
• This message appears if the Tab
LINE This message appears if the number
LIMIT! of lines in the text is greater than the
maximum number of lines possible
for the installed tape.
MEMORY This message appears if you try to
FULL! store a text file after the maximum
number of characters has already
been stored in the memory.
NO This message appears if you try to
FILES! recall or delete a text file from the
memory when none are stored.
NO This message appears if you try to print
TAPE! a label or feed the tape when no tape
cassette is installed.
REPLACE This message appears if the installed
BATTERIES! alkaline batteries are about to run
out.
ROM This message appears if there is a
PROBLEM! problem with the machine's read
only memory.
Cause
longer than 3' 3 1/3" (1 meter) when
you try to print.
function is used to set a label
length that is less than 1.6" (4.0
cm) or more than 11.8" (30.0 cm).
Length function is used to set a tab
length that is more than 11.8"
(30.0 cm).
Remedy
• Shorten the text to less than 3'
3 1/3" (1 meter) before trying
to print.
• Set the label length between
1.6" (4.0 cm) and 11.8" (30.0
cm).
• Set the tab length so that it is
less than 11.8" (30.0 cm).
Reduce the number of lines or
install a tape of greater width.
Delete an unwanted file to make
room for the new one.
Store a text file first.
Install a tape cassette and try
again.
Replace the batteries or use the
AC adaptor.
Turn off the machine, and then
while holding down c and
R, turn the machine back on.
Contact your service representa-
tive.
49