Okoru Global MasterSun MAXIM Manual De Instrucciones página 17

Figure 3:
Use 14-mm masonry drill to drill 9 cm deep holes.
Step 4: Insert Heavy Duty Anchors
After drilling, clean the holes by blowing them out. Then insert the heavy duty
anchors into the holes.
Before inserting lose the nut, washer and clamp ring. Put them at the side, so
that you have it at your fingertips.
It may be necessary to drive in the anchor bolts with a wooden hammer
because they do not go in easily. First loosely screw a nut on the screw of the
heavy duty anchor. Screw the nut to the outer metal edge of the heavy duty
anchor, make sure the nut loose so that the cone on the back cannot be pulled
into the metal jacket and spread it. Now, the power of impact will also be
effective to the jacket, so that not only the cone will not be pushed out of
the anchor, but that the jacket will be moved into the hole too. Only use light
impact to drive the heavy duty anchor into the wall. Caution: To hart impacts
might damage the heavy duty anchor! If you have doubts pull out the anchor
and drill the hole again, but do not make it bigger.
Attention! If you find that there is no resistance when you pull out
the nut of the heavy duty anchor, then the heavy duty anchor has not
enough anchorage. You have to repeat the complete mounting with a
minimum offset of 15 cm!
For correct mounting jacket of heavy duty anchor must be inserted
completely, it may not overlap! If necessary remove the anchor and drill
the hole deeper.
Step 5: Fixing the brackets
Place the bracket on the screw protruding from the wall. Make it a little loose.
Then add flat washer and spring washer and fix the bracket with lock nuts.
Tighten them well.
It is also possible to fix the awning under a concrete ceiling. If you want to fix
the awning under a concrete ceiling you must consult a professional expert for
this kind of mounting.