Air Conditioner Use; Starting Your Air Conditioner - Whirlpool ACQ082XK1 Manual De Uso

A. Green ground wire
B. Ground screw
4. Install foam seal in the gap between air conditioner base and
cabinet. Push foam seal in at the sides and trim any excess
material.
A. Foam seal
5. Remove the 2 front panel screws from air conditioner base.
6. Insert front tabs of front panel into top of cabinet and swing
front into place.
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
If you turn the air conditioner off, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
A
+ +
B
+
A

AIR CONDITIONER USE

7. Attach bottom front of panel with front panel screws. Replace
control knobs (on some models).
NOTE: Route power supply cord through notch in front panel.
B
A. Front panel screws
B. Power supply cord notch
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
8. Plug into a grounded 3 prong outlet.

Starting Your Air Conditioner

Power
ON/OFF
AUTO
COOL TURBO
FAN HIGH
POWER
LOW
SAVER
FAN
MODE
SPEED
A
TIMER
ON/OFF
9