Precision Tech LUMINA Instrucciones De Uso página 13

OPERATION:
• Turn on the curing light by press twice ON/OFF switch.
• The curing light is preset at
• To change the time, press time switch for 0.5 second, select time for 05 10 15 20 25
• To change the mode, press mode switch for 0.5 second, select
time
0 25s
FULL
• Every change of time or OUTPUT, there will be a 'beep' sound. The curing light will keep the last
program selected in memory.
• Put on the disposable curing light sleeve to cover the whole curing light for cross-infection control.
Put on the light protective shield and head protective ring and the curing light is ready for use.
• Remove and dispose of the curing light sleeves after every patient.
• Curing light will automatically turn off if not in use for 1 minute.
CLEANING AND STERILIZATION
Direct light source head, handpiece and charging station can be wiped with non-alcohol based
disinfectant wipes for cold sterilization only, Protective light shield and heat protective ring are
autoclavable, steam sterilize shield and ring at 121°C (250°F) for minimum 15 minutes as per ISO 17665-1.
TROUBLE SHOOTING
FU Battery is full
CH Battery is charging
Battery is low
Lo
4.1 - 3.5 Battery is normal
WARRANTY
Curing light is warranted to the original purchaser against any defective workmanship and
materials under accepted installation, use, and service for a period of 12 months from
date of purchase.
WARNINGS
1) For use by trained dental professionals only.
2) This unit must be used in strict conformity with these instructions.
The manufacturer rejects all liabilities if these rules are not followed or if the unit is used for
any other applications.
3) The light radiation produced by this type of unit can be dangerous and must not be pointed.
at the eyes. The light produced by this equipment must be directed only at the zone to be treated
in the oral cavity.
4) Do not use the unit near a heat source. Do not use solvents, detergents or flammable products,
which may damage the unit or cause short-circuit.
5) Prevent any liquid from entering the handpiece, charging station or transformer.
6) Never modify the device or any of its equipment. Any modification may compromise its safety
and effectiveness.
7) The LED Lamp is not field-repairable. Do not disassemble this product. Unqualified repairing or tampering
with internal parts may lead to serious injury and will VOID manufacturer's warranty.
8) Use only with adapter provided by manufacturer.
9) Before every use, check the device. Do not use the device if it is damaged in any way.
The continuous use of a damaged unit may cause injury or improper results.
10) Do not position the device in a position where it is difficult to disconnect from the supply mains.
11) If not using the device for a long time, please charge at least 4 hours once a month.
12) When charging, the device cannot work.
FULL 100% mode for 10 seconds
time
0 5s 25s
RAMP
E1
E2
E3
FULL, RAMP, 75%OUTPUT
100%
75%
time
0 25s
75% OUTPUT
LED Light head/bulb is not connected well
(call qualified technician to repair)
Battery failure, replace battery
(call qualified technician to repair)
Light temperature too high, wait for
a few minutes and restart
11