Filter Maintenance; Paper Bag Filter; Trouble Shooting - Zanussi Z20 El Manual Del Propietario

FILTER MAINTENANCE

The internal filter is permanent and self cleaning.
However, if you have questions about your permanent self-cleaning
filter, please contact your local authorized dealer/distributor.
PAPER BAG FILTERS
- OPTIONAL
The volume of the bag is 22 liters. A full dust bag reduces the systems performance.
Depending on how often you use your central vacuum system, the dust bag
may need to be changed 2-3 times per year – and can be obtained at your local
dealer/distributor.
Instructions for changing the dust bag:
1. Remove the power unit dirt receptacle.
2. Loosen the dust bag from the intake tube, remove and dispose.
3. Place and press the new dust bag firmly into the tube.
Turn the dust bag's opening to make it fasten firmly on the tube.
4. Put the dirt receptacle back on the central power unit.
Refer to page 39 - Image 10
IF YOU EXPERIENCE TROUBLE WITH YOUR
CENTRAL VACUUM SYSTEM, FOLLOW THE
SUGGESTIONS BELOW BEFORE CALLING
FOR SERVICE.
PARTIAL/TOTAL LOSS OF SUCTION POWER
• Be sure dirt receptacle is on properly.
• Empty dirt receptacle.
• Remove debris from filter.
• Be sure each inlet valve is properly closed.
CLEAR BLOCKAGE IN PIPES
Blockage in the hose
Plug hose into any inlet valve. If there is no suction through the hose after
connecting at a couple of inlets, the blockage is in the hose. To clear the
hose obstruction, insert a blunt instrument into the hose (garden hose, wood
dowel). You can also attempt to reverse the suction through the hose to
dislodge the blockage.
Refer to page 39 - Image 12 and 13
If there is one inlet valve without normal suction and you have checked for hose
blockage, then the blockage is in the pipe system between the blocked inlet valve
and the power unit (see instructions below).
Insert the hose into the inlet valve where there is no suction; hold your hand over
the hose end. Release hand quickly. Repeat several times. If blockage does not
clear, contact your nearest dealer/distributor.
POWER UNIT WILL NOT START
• Check for blown fuse or circuit breaker in main house electric supply box.
• Unplug and check all wall inlet and low voltage connections for loose wires.
• If unit still will not start, contact your nearest authorized service station/dealer.
POWER UNIT WILL NOT STOP
• Check inside each inlet valve for obstruction of low-voltage contacts.
If no visual obstruction can be detected, disconnect the cleaner from the
power receptacle and contact your authorized dealer/distributor.
CENTRAL POWER UNIT SHUTS OFF BY ITSELF
• Remove and then re-insert hose into inlet or toggle switch off-on located
on hose handle. See "Overload Protection".
WARRANTY
Warranty is handled by your local authorized dealer/distributor. Please contact
you local authorized dealer/distributor for questions regarding warranty.
7