Automatic Selection Of Bt Input [ Sel ]; Ir Learning Function - PORSCHE DESIGN 911 Manual De Instrucciones

AUTOMATIC SELECTION OF BT INPUT [ SEL ]

When this function is activated [ AUT ], the 911 Soundbar automatically switches to the BT input when it detects an audio signal from your device.
When this function is deactivated [ MAN ], the input must be selected manually.
The device is supplied with this function deactivated [ MAN ].
To activate/deactivate this function, proceed with the following steps:
With the device switched on, press and hold the 'Play Mode' key for more than 3 seconds, until
1
Press the 'Play Mode' key again briefly, until appears on the display.
2 SEL
Press the 'Volume +' key to activate the function [ AUT ].
3
Press the 'Volume –' key to deactivate the function [ MAN ].
4
5 Exit the menu by again pressing and holding the 'Play Mode' key for more than 3 seconds.
If no input is given within 10 seconds, the device will automatically exit the configuration menu.
Comment: Depending on the used end device, the 911 Soundbar can also be switched to the BT input by typing a message or by sound of other
system tones if the SEL function is activated [ AUT ].
When the SEL function is activated [ AUT ], the BT input can no longer be selected using the 'Input' key. In this mode, the 911 Soundbar can be
connected to the end device regardless of the selected signal input
DS_Betriebsanleitung_911_Soundbar_210x148mm_RZ_Teil_1_v19.indd 52-53
appears on the display.
AUT
.
BTP

IR LEARNING FUNCTION

The 911 Soundbar can learn the infrared code of your TV remote control and therefore allows you to control the functions of the 911 Soundbar and
TV device via one remote control. The 911 Soundbar can learn any arbitrary button on your television remote. When choosing a key, make sure that
the instructions for the 911 Soundbar do not conflict with the TV device. We recommend that you deactivate the internal loudspeaker of the TV device
once the 911 Soundbar is connected.
1 Hold the TV remote control in position.
Switch the 911 Soundbar on.
2
Press and hold the 'On/Standby' key of the Porsche remote control for
3
approx. 5 seconds.
The display shows a flashing .
4 IRL
Press the wanted function on the Porsche remote control, e. g. 'Volume +'.
5
Now the display shows the chosen function, e. g. .
6 V
Within 20 seconds, press the key you wish to allocate this function to on
7
the TV remote control.
Once this has been successfully allocated, the display will show
8
and you can continue with the programming of the next key function, e. g.
'Volume –'.
If the display shows this means the allocation has failed and you
9 FAI
should repeat steps 5 to 8.
[ EN ] 911 Soundbar
ON
STANDBY
TV remote control
Note: The red 'On/Standby' key on the Porsche remote control has
OK
a dual function. Press it once and the display will show
which allows the switching-on function to be programmed. If the
red 'On/Standby' key on the Porsche remote control is pressed twice
in quick succession, the display will show
STB
or switching-off function can be programmed. If your TV remote
control has only one key for the 'On' and 'Off' functions, both the 'On'
and 'Standby' functions must still be allocated with this command.
,
ON
and the standby
52 | 53
22.09.16 17:48