Tabla de contenido
Idiomas disponibles
Idiomas disponibles
USE OF EXTENSION CORDS
Make sure the extension cord is in good condition before using. Always use the proper
size extension cords with the tool – that is, proper wire size for various lengths of cord and
heavy enough to carry the current the tool will draw. Use of an undersized cord will cause
a drop in line voltage resulting in loss of power and overheating. For proper size cords see
chart below.
Volts
120V
240V
Ampere Rating
More
Than
0
6
10
12
MOTOR
Be sure your power supply agrees with nameplate marking. 120 Volts AC only means your
tool will operate on standard 60 Hz household power. Do not operate AC tools on DC. A
rating of 120 volts AC/DC means that you tool will operate on standard 60 Hz AC or DC
power. This information is printed on the nameplate. Lower voltage will cause loss of
power and can result in over-heating. All Black & Decker tools are factory-tested; if this
tool does not operate, check the power supply.
FUNCTIONAL DESCRIPTION
1. Two speed switch
2. Support stand
3. Air vents
4. Hot air nozzle
Tool Operation
SWITCH
The position of the switch controls both the fan speed and
the heat output of the gun.
• To turn the tool on in low speed, low heat, depress the side of
the switch marked "I".
• To turn the tool on in high speed, high heat, depress the side
of the switch marked "II".
• To turn the tool off, return the switch to the middle position marked "O".
Minimum Gage for Cord Sets
Total Length of Cord in Feet
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Not more
Than
-
6
18
-
10
18
-
12
16
-
16
14
26-50
51-100
51-100
101-200
American Wire Gage
16
16
16
14
16
14
12
Not Recommended
A
4
6
101-150
201-300
14
12
12
1
B
3
2
Tabla de contenido
