Tabla de contenido
Idiomas disponibles
Idiomas disponibles
i iiml
i i|1
SERVICE AND ADJUSTMENTS
TO REPLACE BELT
The drive belt on this snow thrower is of special
constructionand should be replacedwith originalequip-
ment belts available from your nearest SEARS Store or
Service Center.
If your snow thrower will not discharge snow, and the
auger drive belt isdamaged, replace it as follows:
•
Disconnectthe spark plug wire,
•
Remove the belt cover (See FIG. 4).
•
Loosen the belt guides (See FIG. 5) and pull away
from the auger drive pulley.
•
Slip belt from auger drive pulley.
•
Pull auger idler pulley to the engaged position,
releasingbrake.
•
Slip belt from belween brake arm and pulley.
•
Remove old belt.
•
Installnewreplacement beltofthe same typeontothe
auger pulley.
•
Positionbelt onto auger drivepulley.
•
Adjust the belt guides (See To Adjust The Belt
Guides paragraph).
•
Reinstalltl_ebelt cover.
•
Checkthe clutchcontrolcable adjustment(See page
17),
•
Reconnectthe spark plug wire.
TO ADJUST THE BELT GUIDES
•
Disconnectthe spark plug wire.
•
Remove the belt cover by removing the screw and
flatwasheron the left and right hand sides (See FIG.
4).
•
Engage the auger drive clutch lever.
•
Measure the distance between the belt guides and the
belt (See FIG. 6). The distance should be 3/32" for
each guide.
•
If adjustment is necessary, loosen the belt guide
mounting bolts. Move the belt guides to the correct
position. Tighten the mounting bolts.
•
Reinstall the belt cover.
•
Reconnect the spark plug wire.
FIG. 4
DRIVE
B ELT
BELT GUIDE
(Right Hand)
BELT GUIDE
Left Hand)
DRIVE
PULLEY
AUGER IDLER
PULLEY
FIG. 5
AUGER DRIVE PULLEY
3f32 INCH'__
BELT GUIDE
(,.,,..a.,)A ---\V"
FIG. 6
18
Tabla de contenido
