Tabla de contenido
Idiomas disponibles
Idiomas disponibles
REAR PANEL FEATURES
AC IN – Use the included
1.
power adapter to connect
the mixer to a power outlet.
While the mixer's power is
switched off, plug the power
supply into the mixer first,
then plug the power supply
into a power outlet.
Note: The mixer is designed
to work with the included AC
power supply only. Using an
incompatible power supply
could damage the unit.
POWER SWITCH – Turns the mixer on and off. Turn on the mixer after all input devices have been
2.
connected and before you turn on amplifiers. Turn off amplifiers before you turn off the mixer.
LINE INPUTS (RCA) – Connect line-level devices, such as CD players, samplers or audio interfaces,
3.
to these inputs.
PHONO INPUTS (RCA) – Connect your audio sources to these inputs. These inputs can accept both
4.
line and phono-level signals. (See #5 below.)
AUX LINE / PHONO SWITCH – Flip this switch to the appropriate position, depending on the device
5.
connected to the PHONO inputs. If you are using phono-level turntables, set this switch to "PHONO" to
provide the additional amplification needed for phono-level signals. If using a line-level device, such as
a CD player or sampler, set this switch to "LINE".
GROUNDING TERMINAL – If you are using phono-level turntables with a grounding wire, connect the
6.
grounding wire to these terminals. If you experience a low "hum" or "buzz", this could mean that your
turntables are not grounded.
Note: Some turntables have a grounding wire built into the RCA connection and, therefore, nothing
needs to be connected to the grounding terminal.
MASTER OUTPUT (RCA) – Use standard RCA cables to connect this output to a speaker or amplifier
7.
system. The level of this output is controlled by the MASTER knob on the top panel.
RECORD OUTPUT (RCA) – Use standard RCA cables to connect this output to a recording device,
8.
such as a CD recorder or tape deck. The level of this output is based upon pre-master levels.
FRONT PANEL FEATURES
1.
HEADPHONES OUTPUT –
Connect
your
headphones to this output
for
cueing
monitoring.
output controls are located
on the top panel.
2.
CUE VOLUME – Adjusts the
volume
level
headphone output.
3.
CUE TONE – Adjusts the tone of the headphone audio signal. Turn this knob to the left to emphasize
low (bass) frequencies or turn to the right to emphasize high (treble) frequencies.
4.
CUE SLIDER – Monitors the audio playing on Channels 1 and 2. Sliding to the left plays Channel 1.
Sliding to the right plays Channel 2.
5.
MIC INPUT – Connect a ¼" microphone to this input.
6.
MIC GAIN – Adjusts the audio level of the microphone signal.
7.
MIC TONE – Adjusts the tone of the microphone signal. Turn this knob to the left to emphasize low
(bass) frequencies or turn to the right to emphasize high (treble) frequencies.
Tip: If you experience feedback when using a microphone at loud levels, try turning down high
frequencies by turning the knob to the left.
POWER
INPUT VOLTAGE
10V A C~500 m A
¼"
and
mix
Headphone
of
the
2
1
7
6
5
5
OUTPUTS
CH2
CH1
GROUND
AUX LINE
PHONO
AUX LINE
6
5
3
8
3
4
7
MASTER
RECOR D
LINE
PHONO
LINE
4
3
2
PHONO
5
4
PHONO
1
Tabla de contenido
