Global 246103 Manual Del Usuario página 4

INSTALLING INSTRUCTIONS
All wiring must be installed by a certified electrician
according to the local electrical codes. The ceiling
heater must be grounded in accordance with all
national and local building codes.
All wiring procedures and connections shall be in accordance
with the national and local codes having jurisdiction.
Before installation:
Disconnect the main supply connection.
The heater must be connected to individual branch circuit.
Installation location:
1.Arrange units so their discharge air streams are subjected to a
minimum of interference from columns and partitions.
2.Direct air stream away from room occupants.
3.Do not blow air steam directly at wall.
4.Direct air stream along the windward side of a room when
installed in a building exposed to a prevailing wind.
5.If using a remote thermostat, locate thermostat approximately 5
feet above partition walls or posts away from cold drafts, internal
heat sources, and away from heater discharge air streams.
6.Large rooms require multi-unit installations. Arrange units to
provide perimeter air circulation where each unit supports the air
stream from another.
MOUNTING
Table 1 -Wall and Ceiling Clearance, inches(mm) / Mounting
Brackets
Table 2 - Mounting Rod Spacing
Rod
Rod
Thread
Length
Type
at least
5/16-18
250mm
ROD MOUNTING
HORIZONTAL DISCHARGE
NOTE: Mounting rods not included. Mounting rods need to contain a 5/16"-18 thread size and must be a minimum of 7.5" long.
1.Remove the four bolts from the threaded holes on the top of the heater.
2. Install four threaded mounting rods (not included) in the threaded holes of the heater and secure in place using lock nuts.
3. Securely attach the four mounting rods to the ceiling.
Refer to Table 1 for wall and ceiling clearances and Table 2 for mounting rod spacing.
Ceiling
7" Min. Clearance to Floor
Figure 3 - Horizontal Discharge Mounting and Spacing
Horizontal Unit Heater
Horizontal
(Figure 3)
A B C
6 8 5
1 /16" 7 /8" 1 /8"
Mounting
Rod(4) - not
included
Lock Nut
A
Unit Heater
Threaded Mounting
Holes(4)
High temperature, risk of fire, keep electrical
cords, drapery, furnishings, and other
combustibles at least 3 feet (0.9 m) from the
front of the heater and away from the side
Vertical
(Figure 4)
D E F
8 14
3/4"
7 /8" 5 /8"
Back Wall
B
D
C
4
User's Manual
and rear.
G H
5
2"
1 /8"
Threaded Mounting Holes(4)
for Horizontal discharge